Manufacturing origin : Swiss
Voltage : 380 / 50 / 3
Netweight : 4900 lbs
Custom position : 8460.2920
TECHNICAL DATA
Nominal distance between centre : 600 mm
Max. distance between centres, headstock and tailstock
projecting : 750 mm
Height of centres, standard : 125 mm
Height of centres by means of raising blocks for work :
head-and tailstock : 175 => 250 mm
Max. swing diameter with 125 mm height of centres : 250 mm
Max. swing diameter with raising blocks : 350 => 500 mm
Table swivels each side : 10°
Max. lenght for surface grinding (width=200 mm) : 900 mm
Table speed infinitely viable by hydraulic drive, approx. .. : 6 m/min
Dwell of table reversal : 0 – 5 sec.
Grinding wheel for cylinrical grinding
(diameter x width x hole) : 350/400x50x127mm
Grinding wheel for surface grinding diameter x width x hole : 250 x 13 x 76
Speeds of grinding wheel spindle : 1500/1700/2200/3600
Grinding wheel head swivels : 270°
with indexed stop each : 90°
Vertical movement of grinding wheel head, height of
centres : -350 mm
Cross movement of grinding wheel head : 285 mm
Rapid advance and withdrawal of wheelhead : 40 mm
Intermittent infeed per reversal of table : 0,001-0,03 mm/dia
Infeed for plunge grinding : 0-0,9 mm/dia
Micro-corrector of infeed, 1 division of dial : 0,001 mm/dia
Swivel of work headstock : 360°
work speeds infinetely viable, normal/special : 20-400/10-400
Internal taper of headstock/tailstock : 5/3 Morse
Grinding wheel motor, approx. : 4 HP
errors and omissions excepted data given without obligation
Inventory Nr.2170089, machine equipped with :
1 Workpiece headstock MT5
1 sinus rule without comparator
1 Wheel headstock with 4 pulleys
1 Tailstock MT3
1 Collet clamping device with drawbar and reduction sleeve B32
1 Internal grinding device with quill Fischer UJ50x250 – pulley Ø 48 for 14000 min-1
1 Pivoting wheel trueing-up device with sole 50 mm
1 Table’s pivoting stop without comparator
1 Cooling device through decantation
1 extractor
1 balancing stake