CYLINDRICAL GRINDING MACHINE

complete retrofit, between centres 1600 mm., centres

Between centres 650 mm and centres height 125 mm
2x OD and 1x ID with spindle 45'000 min-1

Completely overhauled:

Mechanics, geometry, hydraulics and electrical parts (checked and/or replaced)

Grinding headstock
Dismantling, cleaning parts, replacing worn and defective parts, overhauling the motor, replacing bearings, replacing belts, dismantling spindle, replacing seals and O-Rings + adjustment. New paintwork.

Headstock
Dismantle, clean parts, replace worn and faulty parts, replace motor, replace belts. New spindle bearings. New paintwork.

Tailstock
Dismantle, clean parts, replace worn and faulty parts, replace motor, replace belts. New spindle bearings. New paintwork.

Internal grinding device
Dismantling, cleaning parts, replacing worn and defective parts, fitting support and aligning geometry. New paintwork.

Hydraulics
Dismantle, replace motor, replace hoses, defective and worn parts. Check hydraulic block
X axis
Dismantling, replace worn parts such as O-Ring, seals, rings etc., overhaul hydraulic piston, rectify tables.

Z axis
Dismantling, grinding the tables, replacing worn and defective parts, overhauling the hydraulic piston, scraping the V and flat guides. New paintwork.

Measuring system
2-axis digital display included

Electrical cabinet
Replace motor terms and relay controls. New wiring. New variable speed drive for workpiece stern.

Paint
Colours: White RAL 9003 and grey RAL 7011

Geometry according to manufacturer's protocol.